HOME > Products > Hardware & Riggings > Prolyte Group
Prolyte Group
Prolyte Group logo
Prolyte Group
1990년 설립. Netherland 업체.
모터 호이스트, 트러스 및 무대장치 등을 제조 공급하고 있는 Prolyte group은 정숙성과, 정확성 및 안전성을 추구하며 ProLyft AETOS hoist는 독자적인 Before & After Service 운영과 Life Time Warranty로 2014' Plasa Show에서 올해의 제품으로 선정되기도 하였습니다.
AETOS Hoist AETOS Controller AETOS Accessories Manual Chain Hoist Prolyte Truss
Accessories Towers Roof Systems STAGE Floor

CT Tower
제조사 Prolyte Group
원산지 Netherland

The CT tower uses several sleeve blocks that combine all the trusses from the S and B Series.


The CT tower is based on C52T mast sections. These mast sections have onesided horizontal bracing to facilitate safe and easy climbing of the towers. C52T truss is constructed of main tubes of 60 x 5 mm and diagonals of 30 x 3/48 x 3 mm. Use the CCS7 coupling system with the CCS7-704 or CCS7-703-C52T shortened spigot pin. The base section of the CT tower is similar to the ST tower; the outside dimensions and setup are the same. Extra spindles are added to the base section to absorb the extra forces resulting from the tower’s higher loading capacity. Existing ST base sections can be upgraded to accommodate CT towers on request. 

The CT tower uses several sleeve blocks that combine all the trusses from the S and B Series. This makes it possible to fit almost all S Series trusses to all four sides by means of bolted female CCS7 couplers. The outside dimensions of the CT sleeve block are the same as the ST sleeve block; both can be combined in one grid. The CT tower has a self-weight of 140 kg. The CT sleeve block is a fully bolted structural element, making it much stronger and more precise than conventional welded versions. 

# 07547 서울 특별시 강서구 양천로 583, 우림블루나인 비즈니스 센터 B동 2001호     대표전화 02-2093-1002 팩스 02-2093-1003
COPYRIGHT 2015 ⓒ Tongsuh Technology Co., Ltd. ALL RIGHTS RESERVED.